Device Information
Model
Not Connected
Serial Number
—
Firmware Date
—
Boot Date
—
Connection
—
ESC Configurator
F-Series - Config + Passthrough Interface
ESC Mode
Normal: 0-100% throttle. Reversible: 0%=full reverse, 50%=stop, 100%=full forward. Reversible locks input to PWM.
Mode
Status
Normal Mode
Recommended Presets
Load defaults for a use case. Remember to Write Settings to apply.
Motor Drive Settings
Direction
Start Power
Startup torque
Timing Advance
Auto is recommended. Disabling allows manual control for advanced tuning.
Auto Timing
Timing Advance
12
PWM Drive Frequency
Auto is recommended for most setups.
Auto PWM Freq
Frequency
Response Rates
Ramp-Up (%/100ms)
100
Ramp-Down (%/100ms)
100
Dead Zone (%)
10
Dead zone only applies in reversible mode.
Current & Temperature
Bus Current (A)
120A
Temp Limit (°C)
120°C
Over-Temp Response
Telemetry
Enabled
Type
Motor Features
F5B Startup
Super fast startup for F5B. May damage drivetrain if misused.
Brake On Stop
Motor Beep
Beep
Endpoints
Auto Endpoints
Lower (µS)
1100
Upper (µS)
1900
Available Firmware Revisions
Revisions are fetched from APD servers on page load. Download the firmware file, then use the flash section below to write it to the ESC.
Status icons: ✓ = Installed,
⚠ = Boot Incompatible,
B = Beta.
Loading revisions...
Flash Firmware
Select a firmware file downloaded from above (.bin for UART, .hex for Passthrough).
Ensure propellers are removed before flashing.
Firmware File
No file selected
Manual Command
Command
Export
Console